GE Monogram ZV750 Installation Instructions Manual page 8

Installation
36" Vent Hood
s 4
Install
Mounting
Brackets
Whenever possible, the vent hood should be
secured to wall studs.
• XVith the template roped in place, use a
puncll to mark all mounting screw locations.
• Drill 1/8" pilot holes at the 6 punched
locations.
• Remove the template.
• Enlarge holes that did not enter studs to
3/8" and tap anchors for wall fasteners into
the holes.
- Drive screws into the fasteners to allow
anchors to expand against the wall
material. Remove the screws for final
installation.
• Secure the mounting brackets to the wall
studs with wood screws provided.
- For hollow walls, secure the mounting
brackets through the anchors.
1
Note:Screws "A" and "B" are pre-assembled onto the brackets.
Do not remove these screws.
Install
the Hood
Place the hood on the brackets and slide left to
right to align with rectangular slots at the top.
• Adjust the installation height by tightening
or loosening the screws "A" at the bottom
of the brackets.
• Align the hood lower mounting holes with
pilot holes in the wall.
• Using two large fiat washers (supplied),
install wood screws or wall fastener screws,
loosely, into lower mounting holes. Do not
tighten.
• I,evel the hood by tightening or loosening
the screws "A" located on the bottom
mounting brackets.
• Tighten the lower mounting screws.
• Tighten screws "B" located at the top of the
mounting bracket against the hood to clamp
the position. Do not overtighten screws.
Screws"B"
ToSecureHood
ToWall
/--...
--Leveland
Height
Adjustment
Screws"A"
Lower
MountingScrews