GE Monogram ZV750 Installation Instructions Manual page 10

Installation
36" Vent Hood
Connect
Ductwork
Do not use sheet metal
screws at hood flange
connection. Doing so will prevent proper
damper operation. Seal connection with
rope only.
Install ductwork, making connections in
direction of airflow as illustrated.
Secure joints in ductwork with sheeuneml
screws.
Wrap all duct joints with duct rope for
airtight seal.
Duct Tape
Over Seam
and Screw
Air Flow
Screw
Step 8
Connect
Electrical
Verify that power is turned off at the source.
If house wiring is not 2-wire with
a ground wire, a ground must be
provided by the insmlleL
When house wiring is aluminum,
be sure to use U.I,. approved
anti-oxidant compound and
aluminum-to-copper connectors.
• Insert house wiring through suain relief
and tighten.
• Connect white leads to branch circuit
white lead.
• Connect black leads to branch circuit
black lead.
• Connect green/yellow leads to branch
circuit green or bare ground lead.
• Secure all connections with wire ntlts oil
each electrical connectoL
• Push wires into junction box and replace
coveL Be sure wires are not pinched.
Step
9
Install
Decorative
Duct Cover
and
Utility
Bars
1o
Mounting Screws
/ Notches
Place the decorative duct cover on top of
the hood.
• Insert the lower portion of the duct cover
into the impression on the top of the hood.
• Extend the inner duct upwards to meet the
ceiling and bracket.
• Secure the duct cover to the bracket with
the 2 small Phillips screws provided.
• Install the side utility bars as shown with
screws provided.
Install Optional ZXl OSY Duct Cover
• Separate the supplied duct cover into
pieces. Discard the upper (or inner)
section.
• Insert the new ZX10SY duct cover into
the original lower section. Be sure that
the new longer section is inside the shorter
original section. The notches will be at the
bottom and the screw holes at the top as
illustrated.
• Follow the same procedures shown above
to install the new duct cover.