GE Monogram ZV750 Installation Instructions Manual page 7

Installation
36" Vent Hood
Check
Installation
Hardware
Ductwork,
Wiring,
Hood
Attachment
Locations
I,ocate tim hardware accessory box packed
with range hood and check contents.
10
Wall
Fasteners
2 Mounting
Brackets
iFT
Ph,,,, ead Screws
Utility Bars with Screws
3 Filters
_-x
2 Large
FlatWashers
lO
Wood
Screws
Decorative
Duct
Wall Mount Template
To determine ductwork locations:
• I,ocate the template packed with the
literature.
• Determine tim exact installation location.
- Measure 36" flom tim floor to tim top
of the cooking surface. Add 25-1/2"
recommended space flom the cooking
surface to bottom of hood. Mark that
location.
- Use a level to draw a straight pencil line
on tim wall.
- Tape tim template in position along the
penciled line. CHECK TO BE SURE
TEMPI,ATE IS I,EVEI,.
• Measure flom the peak of the hood
to the ceiling as indicated. The dimension
should be:
- 26-1/4" to 38-1/4" for 8 ft. to 9 ft. ceilings.
- 38-1/4" to 50-1/4" for 9 ft. to 10 ft.
ceilings (This installation requires
ZX10SY accesso_ T duct covet,)
CEILING DUCTING
If ductwork will vent straight tap to tim ceiling:
• Use a level to draw a line straight tap, flom
,/FOB CEILING
3 1/2" Wall',./VENT_ DUCTING Centerline To
/r"
6-1/2"Die.Hole_
,,
\\\\\ i
X J.
.Centerline
2{,_ 6' Min. Above
FOB WALL VENTDUCT [ Bracket L ocation
i
i
i
WALL DUCTING
If ductwork will vent to the rear:
• Use tim level to draw a line suaight tap flom
the centerline on the template.
• Measure at least 6" above tim bracket location
shown on tim template to tim centerline of
the 6-1/2" dia. duct hole. (Hole may need to
be elongated for duct elbow.)
the centerline on the template to the ceiling. HOUSE WIRING LOCATION:
• Measure 3-1/2" fiom the back wall to the
centerline of a 6-1/2" dia. hole on the
ceiling. •
Note: If drywallis not present, a dddrywallthickness to the
3-1/2" dimension.
The junction box is located on the top of the
hood, at tim flont right side.
Rotate house wiring as close to tim installation
location as possible, through the ceiling, soffit
or back wall. Wiring should enter at least 4"
above tim bracket on tim right side. 7