GE Monogram ZV750 Installation Instructions Manual page 3

Design Intormation
36" Vent Hood
Model
Available
Model
ZV750
This vent hood is designed to be used in
vented installations.
A decorative duct cover is provided to cover
the duct flom tile top of tile hood to an 8 ft.
or 9 ft. ceiling.
Optional
Accessories
Model
ZX 10SY
An optional stainless steel duct cover is
available for 9 ft. to 10 ft. ceiling installations.
(Tile supplied duct covet is sized to reach 8 ft.
to 9 ft. ceilings.) Order tile optional duct
covet at tile same time as tile vent hood and
have on site before installation.
Product
Dimensions
& Clearances
Tile vent hood
Illttst
be installed 24 and 0
inax.
above tile cooking surface. 25-1/2" is recommended to _[ ;
insure that tile duct cover meets tile ceiling. Tile cooking [
surface should be at least, 6 above tile floor. Installatton | i
will be easier if tile vent hood is installed before tile range | _Height
tooi
or cooktop a ntertop is installed.
8-1/4"
, 34-5/8" * i
21-5/8"
o
"25-1/2" Recommended
t J
l o
o
o
o
o
o
36" Min.
*The distance between the cooking surface and the bottom
of the hood must be at least 24" and upto 36". The 25-1/2"
recommended installation height, above the standard 36"
ceuntertep, will insure duct cover fit to the ceiling.
"26-1/4" for 8 ft. ceiling
38-1/4" for 9 ft. ceiling
38-1/4" to 50-1/4" for 9 ft. to
10 ft. ceiling using optional
accessoryZX16SYDuct Cover
Recirculating Operation
This hood may be installed for
recirculating
operation.
One of tile
following kits is required and must be
ordered with tile hood.
ZXR758 - For lap to 9 ft. ceiling height.
ZXR7510 - For up to 10 ft. ceiling height.
Both tile hood and accessory
must
be on
site at tile time of installation. Follow tile
installation instructions packed with tile
accessory to complete tile installation.