Reset Sensors ? Reset Sensors; Reset Sensors; Using Reset Sensors - Bosch Security Systems User Manual

RESET SENSORS ?

RESET SENSORS ?
RESET SENSORS ? RESET SENSORS ? RESET SENSORS ?
COMMAND 4 7 COMMAND 4 7 COMMAND 4 7 COMMAND 4 7 COMMAND 4 7
Reset Sensors Reset Sensors Reset Sensors
Reset Sensors Reset Sensors
Description Description Description
Description Description
Detection devices, such as smoke detectors and shock
sensors, must be reset after being activated. This
function momentarily removes power from these
sensors to reset them. It also clears point information
from the display, leaving the ALARM SILENCED
message in the display as a reminder that the View
Memory function can be used to view the cleared point
information. Entering a valid passcode and then
pressing the ESC ESC ESC ESC ESC key clears the ALARM SILENCED
message and the event memory. Arming the system also
clears the display and the event memory.

Using Reset Sensors

Using Reset Sensors Using Reset Sensors:
Using Reset Sensors Using Reset Sensors
1. Ensure that the display is at idle disarmed text.
2. Press the COMMAND COMMAND bar. The display shows COMMAND COMMAND
COMMAND
SYSTEM COMMAND SYSTEM COMMAND SYSTEM COMMAND SYSTEM COMMAND SYSTEM COMMAND.
Note: Note: Note: If you prefer, you may use the Command Menu Note: Note:
ALARM SILENCED ALARM SILENCED ALARM SILENCED ALARM SILENCED
If you enter this function and the detector or sensor
ALARM SILENCED ALARM SILENCED ALARM SILENCED ALARM SILENCED
resets momentarily, but then returns to a faulted
condition, the conditions causing the activation may
still be present or the detector may be faulty. Check to
be certain that there is no smoke, fire, or other danger
present.
If you can't reset the detector or sensor contact your
security company.
3. Press the 4 4 4 4 4 key followed by the 7 7 7 7 7 key.
in place of steps 2 and 3 to initiate this
function. Press the MENU
Command Menu, then press NEXT
until you reach the RESET SENSORS ?
prompt. Press ENT ENT. ENT ENT
ENT
4. The display shows SENSORS RESETING
approximately 3 seconds and then goes blank
before returning to idle disarmed text.
MENU key to enter the MENU MENU MENU
NEXT repeatedly NEXT NEXT NEXT
RESET SENSORS ? RESET SENSORS ? RESET SENSORS ? RESET SENSORS ?
SENSORS RESETING for SENSORS RESETING SENSORS RESETING SENSORS RESETING
43