Bosch Security Systems User Manual page 42

WALK TEST ? WALK TEST ? WALK TEST ? continued
WALK TEST ? WALK TEST ? continued
4. The burglary bell sounds for 2 seconds. When
the display panel shows ## PTS TO TEST
can begin. Test each point by first opening and
then closing the door or window. Check the
display after testing each point. For interior
points, walking past the device once is
sufficient. If any point does not test correctly,
contact the security company for service.
5. During the Walk Test you may want to see the
points that remain untested. When point text is
displayed, press ESC
TO TEST. Press the ESC TO TEST TO TEST
TO TEST TO TEST
? ? ? ? ? is displayed. Press ENT
## PTS UNTESTED. Press NEXT ## PTS UNTESTED ## PTS UNTESTED
## PTS UNTESTED ## PTS UNTESTED
of the points that are untested. Move through
this list by pressing the NEXT
the Walk Test, press ESC
is displayed. Press ESC
displayed. Resume testing points. To end the
Walk Test, press ESC
42
continued continued
continued
## PTS TO TEST ## PTS TO TEST ## PTS TO TEST you ## PTS TO TEST
ESC. The display shows ## PTS ESC ESC
ESC
ESC ESC key. VIEW UNTESTED ESC VIEW UNTESTED VIEW UNTESTED VIEW UNTESTED
ESC VIEW UNTESTED
ENT. The display shows ENT ENT
ENT
NEXT NEXT to see a list NEXT
NEXT
NEXT NEXT
NEXT key. To resume NEXT
ESC. # PTS UNTESTED ESC ESC # PTS UNTESTED # PTS UNTESTED # PTS UNTESTED
ESC # PTS UNTESTED
ESC ESC. ## PTS TO TEST ESC ## PTS TO TEST ## PTS TO TEST is ## PTS TO TEST
ESC ## PTS TO TEST
ESC ESC twice. ESC
ESC
6. When all points are tested, 0 PTS TO TEST
displayed. Press ESC
shows ALL PTS TESTED
idle text.
## PTS ## PTS ## PTS
## PTS
0 PTS TO TEST 0 PTS TO TEST
0 PTS TO TEST 0 PTS TO TEST is
ESC ESC. The display momentarily ESC
ESC
ALL PTS TESTED before returning to ALL PTS TESTED ALL PTS TESTED
ALL PTS TESTED