Honeywell TrueSTEAM HM506 Installation Manual page 39

Cut a slit in the insulation half way
around the hose.
Do not cut into the
rubber steam hose.
Insert the hose clamp into
the slit and hook it onto the
rubber hose.
Minimum of
6 inches _
of straight //Clamp
vertical rise.
Clearance hole for hose and insulation.
Seal off unconditioned space with
grommet (not provided) or caulk.
Always install nozzle so the
outlet is pointed up.
Do not route the steam
hose through the hole
in the mounting plate.
If hose slopes downhill...
Downward slope can not be more than
3 feet below humidifier steam outlet.
/
Provide a 212°F rated Tee at the
lowest point, Do not use plastic Tee.
Hose clamps at
/ \ every connection.
/
Minimum upward /
pi /
On straight runs, use
perforated an
Otherwise, support
hose every 12 inches
using provided hooks. Min
Minimum 2
Nozzle at
Clamps upward pitch.
Always consult and follow local
plumbing codes for drain pipe
size and maximum temperature
requirement,
Water in elbow,
M29636
TrueSTEAM Humidification System 69-2285EF--01
37