Haier DWL3025DBBB Installation Manual page 24

INSTALLATION OF CABINET SEAL
1. The DWL 3525, 4035 and 7075 dishwasher models are equipped with a
dishwasher to cabinet seal that aids in dishwasher installation as well as noise
suppression.
2. Follow the installation instructions from the previous page with the following
exceptions:
To install the dishwasher in the cabinet opening slide the dishwasher into the
opening until it is positioned correctly both side to side and front to back. Using
the legs and rear wheels, shims if necessary, adjust the dishwasher up until the
top cabinet seal touches the underside of the countertop and the dishwasher is
level.
It may be necessary to trim the cabinet seal if it extends past the front of the
cabinet surface. To do this mark the seal at the trim point. Pull the dishwasher out
of the opening and remove the seal. Trim the seal using a utility knife or saw.
Reposition the dishwasher in the cabinet opening making sure it is in contact with
the bottom of the countertop, level and centered in the opening.
Screw the top seal to the bottom side of the counter top.
Predrill three holes into each side seal and cabinet. Screw each side seal to the
cabinet.
Check that the door does not contact any of the screws, seals or countertop. If it
does reposition and level the dishwasher so there is clearance.
dishwasher to cabinet seal I
predrill 3 holes in each
side seal and cabinet
23