Haier DWL3025DBBB Installation Manual page 10

YOU MUST HAVE
• A hot water line with 20-120 psi (138-862 kPa) water pressure.
• Inlet water temperature 120 ° F(49° C) minimum at the dishwasher is
recommended.
• 3//' (0.9cm) O.D. tubing with compression fitting or flexible stainless steel
braided fill line (1/2" (1.3cm) minimum plastic tubing is optional but not
recommended).
• A 90 ° elbow with 3//' (0.9cm) N.P.T. external pipe threads
on one end. Do not solder within 6"(15.2cm) from water inlet
va lye.
YOU MUST HAVE
• Use the new drain hose supplied
with your dishwasher. If this is not
suitable, use a new drain hose
with a maximum length of 12
feet (3.7m) that meets all current
AHAM / IAPMO test standards,
is resistant to heat and detergent,
and fits the drain connector on
your dishwasher.
• Have a high drain loop 30 inches
(76.2cm) above the subfloor or
floor.
• Connect drain hose to waste tee
or disposer inlet above drain trap
in house plumbing and 20 inches
(50.8cm) minimum above the floor.
• Use an air gap in the drain line if the drain hose is connected to house
plumbing lower than 20 inches (50.8cm) above subfloor or floor.
• Use V2" (1.3cm) minimum I.D. drain line fittings.
9