Haier DWL3025DBBB Installation Manual page 9

It is the customer's responsibility to contact a qualified electrician to ensure that
the electrical installation is adequate and conforms with all national and local
codes and ordinances.
You must have:
• 120-volt, 60Hz, AC-only, 15- or 20-amp.,fused electrical supply.
• COPPER WIRE ONLY.
We recommend:
• A time-delay fuse or circuit breaker.
• A separate circuit.
IF DIRECT-WIRING DISHWASHER
• Use flexible, armored or non-metallic sheathed copper
wire with grounding wire that meets the wiring
requirements for your home and local codes
and ordinances.
• Use strain relief method provided with house wiring
junction box or install a Ublisted/CSA-certified clamp connector to the house
wiring junction box. If using conduit, use a Ublisted/CSA-certified conduit
connector.
IF CONNECTING DISHWASHER WITH A POWER SUPPLY CORD
• Use a Ublisted, 16-gauge, three-conductor
power supply cord that meets
all local codes and ordinances. Maximum
length of the power supply cord is
6 feet (1.8m).
• A clamp connector to fit a %" (2.2cm)
diameter hole is required to secure power
supply cord to dishwasher terminal box.
• Power supply cord must plug into a mating
three-prong, grounded outlet located in the
cabinet next to the dishwasher opening.
Outlet must meet all local codes and
ordinances.