12.7 Firmware Upgrades
This chapter describes the process for upgrading
firmware in the PLM.
As responsible manufacturers, Lab.gruppen and Dolby
adopt a policy of continuous product development. As
with all software-based products, it may be desirable
from time to time to update the firmware in your PLM
with a more recent version. You can contact your Lab.
gruppen dealer or distributor, or visit the Lab.gruppen
website for details on available updates:
www.labgruppen.com/plm
Firmware upgrades are downloadable from the
Lab.gruppen website.
PLM firmware upgrade is conducted via the network
from the PC running the DLC PLM Edition software.
There are two methods of performing the upgrade:
by using the Firmware Update Utility or by using the
DLC PLM Edition software.
12.7.1 Firmware upgrades using the update
The Firmware Upsate Utility allows fast upgrade for
large networks of Dolby Lake-equipped products.
Follow the steps shown below to use this method
for firmware upgrade.
1.
2.
3.
4.
Figure 12.6: Digital clock setup page
APPLICATION GUIDE 12
utility
Install the latest version of Dolby Lake Controller
PLM Edition software on the Tablet PC normally
used to control the system.
Power on all PLMs and connect to the PC using
a wired network.
On the PC, go to
start > All Programs > DLC
PLM Edition software Vx.y > Firmware
Update Utilities > PLM series FW update
utility (where Vx.y represents the current
version of DLC PLM Edition).
If the PC is configured with multiple network
adapters, select the required network adapter
from the displayed list and tap OK.
PLM Series Operation Manual 69