5-12 Floppy And Sata Ports; Floppy Drive Connector - Supero SuperWorkstation 7046A-HR+ User Manual

S W
uper orkstation 7046A-HR+/7046A-HR+F User's Manual

5-12 Floppy and SATA Ports

Use the following information to connect the IDE hard disk drive cables.
•
A red mark on a wire typically designates the location of pin 1.
•
The 80-wire ATA100/66 IDE hard disk drive cable that came with your system
has two connectors to support two drives. This special cable should be used
to take advantage of the speed this new technology offers. The blue connector
connects to the onboard IDE connector interface and the other connector(s) to
your hard drive(s). Consult the documentation that came with your disk drive for
details on actual jumper locations and settings for the hard disk drive.

Floppy Drive Connector

The fl oppy connector is located be-
side the IDE connector. See the table
below for pin defi nitions.
Floppy Drive Connector
Pin Defi nitions
Pin# Defi nition
1 Ground
3 Ground
5 Key
7 Ground
9 Ground
11 Ground
13 Ground
15 Ground
17 Ground
19 Ground
21 Ground
23 Ground
25 Ground
27 Ground
29 Ground
31 Ground
33 Ground
5-22
Pin # Defi nition
2 FDHDIN
4 Reserved
6 FDEDIN
8 Index
10 Motor Enable
12 Drive Select B
14 Drive Select B
16 Motor Enable
18 DIR
20 STEP
22 Write Data
24 Write Gate
26 Track 00
28 Write Protect
30 Read Data
32 Side 1 Select
34 Diskette