5-12 Floppy, Ide, And Sata Ports; Sata Ports; Floppy Connector - Supero SuperWorkstation 5036T-T User Manual

S W
uper orkstation 5036T-T User's Manual

5-12 Floppy, IDE, and SATA Ports

SATA Ports

Six Serial ATA (SATA) ports (I-SATA
0~5) are located on the motherboard
to provide serial link connections. Se-
rial Link connections provide faster
data transmission than those of the
traditional Parallel ATA. These SATA
ports are supported by the Intel
ICH10R Chip (South Bridge). See the
table on the right for pin defi nitions.

Floppy Connector

The fl oppy connector is located near
the PCI-X slot 1 on the motherboard.
See the table on the right for pin
defi nitions.
Note the following when connecting
the fl oppy cable:
•
The fl oppy disk drive cable has
seven twisted wires.
•
A red mark on a wire typically des-
ignates the location of pin 1.
•
A single fl oppy disk drive ribbon
cable has 34 wires and two con-
nectors to provide for two fl oppy
disk drives. The connector with
twisted wires always connects to
drive A, and the connector that
does not have twisted wires al-
ways connects to drive B.
SATA Port
Pin Defi nitions
(I-SATA0 ~ I-SATA5
Pin # Defi nition
1 Ground
2 TXP
3 TXN
4 Ground
5 RXN
6 RXP
7 Ground
Floppy Drive Connector
Pin Defi nitions (Floppy)
Pin# Defi nition
1 Ground
3 Ground
5 Key
7 Ground
9 Ground
11 Ground
13 Ground
15 Ground
17 Ground
19 Ground
21 Ground
23 Ground
25 Ground
27 Ground
29 Ground
31 Ground
33 Ground
5-24
)
Pin # Defi nition
2 FDHDIN
4 Reserved
6 FDEDIN
8 Index
10 Motor Enable
12 Drive Select B
14 Drive Select B
16 Motor Enable
18 DIR
20 STEP
22 Write Data
24 Write Gate
26 Track 00
28 Write Protect
30 Read Data
32 Side 1 Select
34 Diskette