Make Electrical Connection; Install Vented Range Hood - IKEA IHI8304WS0 Installation Instructions And Use & Care Manual

Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
1. Disconnect power.
2. Remove terminal box cover.
3. Remove the knockout.
A
S ...............
........................ , °
-- ._"@ (
A. Knockout
B. Terminal box cover
4. Install a UL listed or CSA approved strain relief.
I
F
A. Home power supply cable
B. Terminal box cover
C. UL fisted or CSA approved strain relief
D. Green (or bare) wire connected to yellow-green wire
E. White wires
F. Black wires
5. Run 3 wires, black, white and green (14 AWG), in 1/2"conduit
from service panel to terminal box. Use caulking to seal
opening.
6. Use UL listed wire connectors and connect black wires (F)
together.
7. Use UL listed wire connectors and connect white wires (E)
together.
Electrical Shock Hazard
Electrically ground blower.
Connect ground wire to green and yellow ground wire
in terminal box.
Failure to do so can result in death or electrical shock.
8. Use UL listed wire connectors and connect green (or bare)
wire with yellow-green wire (D).
9. Tighten strain relief screws.
10. Replace terminal box cover.
11. Check all light bulbs to make sure they are secure in their
sockets.
12. Reconnect power.
1=
Insert 4 screws on the bottom of the chimney structure (in
corresponding position to the keyhole slots on the hood
canopy).
:\
c_
A. Four screws
2. Lift hood canopy so that the large end of the keyhole slots are
over the 4 screws on the bottom of the chimney structure.
3. Push the hood canopy so that the 4 screws are in the narrow
end of the keyhole slots. Securely tighten the screws.
4. Install the remaining 4 screws and securely tighten.
\ /
Front
8