Safety Information - Martin MAC 101 User Manual

Safety Information

Read the safety precautions in this section before
installing, powering, operating or servicing this
The following symbols are used to identify important safety information on the product and in this manual:
DANGER! DANGER!
Safety hazard. Hazardous
Risk of severe voltage. Risk of
injury or death. lethal or severe
electric shock.
Warning! Risk Group 3 (high risk) LED product according to EN 62471. Do not look into the beam at
a distance of less than 8.3 meters (27 ft. 3 inches) from the front surface of the product. Do not view
the light output with optical instruments or any device that may concentrate the beam.
This product is for professional use only. It is not for household use.
This product presents risks of severe injury or death due to fire and burn hazards, electric shock and falls.
Read this manual before installing, powering or servicing the fixture, follow the safety precautions listed
below and observe all warnings in this manual and printed on the fixture. If you have questions about how to
operate the fixture safely, please contact your Martin supplier or call the Martin 24-hour service hotline on
+45 8740 0000, or in the USA on 1-888-tech-180.
P R O T E C T I O N F R O M E L E C T R I C S H O C K
• Disconnect the fixture from AC power before removing or installing any cover or part and when not in use.
• Always ground (earth) the fixture electrically.
• Use only a source of AC power that complies with local building and electrical codes and has both
overload and ground-fault (earth-fault) protection.
• Before using the fixture, check that all power distribution equipment and cables are in perfect condition
and rated for the current requirements of all connected devices.
• Power input and throughput cables must be 2.5 mm2 (14 AWG) minimum conductor size, with SJT or
better cable jacket type The cable jacket must be heat-resistant to 90° C (194° F) minimum.
• Use only Neutrik PowerCon NAC3FCA cable connectors to connect to power input sockets. Use only
Neutrik PowerCon NAC3FCB cable connectors to connect to power throughput sockets.
• Isolate the fixture from power immediately if the power plug or any seal, cover, cable, or other component
is damaged, defective, deformed, wet or showing signs of overheating. Do not reapply power until repairs
have been completed.
• Do not expose the fixture to rain or moisture.
WARNING!
product.
WARNING! WARNING!
Fire hazard. LED light
emission. Risk of
eye injury.
Safety Information
WARNING! WARNING!
Burn hazard. Hot Wear protective
surface. Do not eyewear.
touch.
WARNING! Refer
to user manual.
3