Table of Contents
Advertisement
INSTALLING ANTI-TIP DEVICE
All ranges must have an antFtip
device
correctly
installed as per the following
instructions.
If you pull the range out
from the wall for any reason, make sure
that the device
is properly
engaged
when you push the range back against
the wall. If it is not, there is a possible
risk of the
range
tipping
over
and
causing injury if you or a child stand, sit
or lean on an open oven door.
INCLUDED
PARTS:
Included
with
this kit are:
(4) #10 x 2"wood
screws,
(1) AntFtip
bracket, and (1)Installation
Instructions.
INSTALLING THE KIT:
Instructions
are provided
for wood
and cement
floors.
Any other type of
construction
may require special instal-
lation techniques
as deemed
necessary
to
provide
adequate
fastening
of the
Anti-tip
bracket to the floor and wall. The use of this bracket
does not preclude
tipping
of the range when
not
properly
installed.
(2)Small Holes for
Wood Installations
(2) Wood Screws into
Back Wall (ALL
Installations)
(2) Large Holes for
BACK
Concrete
Installations
WALL
Fig. 7
A=
I/4"
5/8"
Model
Series
PRD3030
PRD3630
WOOD CONSTRUCTION:
Place the bracket against the back wall, into the right
rear corner where the range is to be located. Leave a
gap between
the wall (or side of range) and the
bracket (see fig.7). Drill (2) 1/8"diameter
pilot holes
in the centerofthe
small holes. A nail or awl may be
used if a drill
is not available.
Fasten the bracket
securely to the floor and wall.
CONCRETE OR CEMENT CONSTRUCTION:
Hardware
Required:
(2) sleeve
anchors,
lag bolts,
and
washers
(not
provided).
Locate the bracket as described
above.
Drill the recommended
size holes for the hardware.
/_
WARNING
= ALL
RANGES
CAN
TiP
i INJURY
COULD
RESULT
® INSTALL
ANTI-TIP
BRACKET
PACKED
INSIDE
OVEN
• SEE INSTRUCTIONS
Fig. 8
Install the sleeve anchors into the holes and then install the lag bolts through
the bracket.The
bolts
must be properly
tightened
as recommended
for the hardware.
Fasten the bracket securely to the
floor and wall.
ONCE INSTALLED:
Complete
the range installation
per the instructions
provided
with the product.
Check for proper
installation
of the range and Anti-tip
device by grasping the back of the unit and carefully attempt
to
tilt the range forward.
Advertisement
Table of Contents
