Configure The System - Harris CM-30 Installation & Operation Manual

4 – Configuration & Operation
Transfer log files when full: Select the check box to enable automatic transfer of log files to an FTP
server when log files are full. You can only select this check box when the Turn on alarm logging
check box is selected.
System Log Filename on FTP Server: Type the name assigned to the system log file on the FTP
server. Default = syslog.txt.
Automatic FTP Transfer
You can only change information in these fields when both the Turn on alarm logging and the
Transfer log files when full check boxes are selected.
Save file to: Type the location to which the system log file is transferred.
FTP Server user name: Type a required FTP username for the remote FTP server.
FTP server address: Type the IP Address of the FTP server to which the NetXpress LX system
offloads system log files.
FTP server password: Type a required FTP server password for the remote FTP server.
syslogd Server
You can only change information in these fields when the Turn on syslogd server support check
box is selected.
Server address: The IP address of the server where the system log directory is to be filed.
Server UDP port number: The UDP port number for the server where the system log directory is to
be filed.
Reset: Click this button to reverse all changes to this page.
Save: Click to apply all changes to this page.
4.3.3

Configure the System

Harris Corporation
Intraplex Products
NetXpress LX & CM-30 Installation & Operation Manual
Access these pages from the System Cfg menu:
General: Configure parameters such as system
identification, date and time, and SNTP server
configurations.
Contacts: Configure input and output contacts.
TDM Bus: View the TDM bus information table, showing
signaling type and time slot activity for each TDM bus.
TDM Bus Mapping: View and map the TDM bus inter-
networking.
System Timing: View timing source information and select
the type of timing stream network.
TOS Byte Definitions: Set the outbound packet TOS byte
definitions.
Software Images: Set the software image management
parameters.
Configuration Backup: Set the configuration backup file
parameters and view the configuration file status table.
Version 1, September 2010
4-21