Configure Streams - Harris CM-30 Installation & Operation Manual

4 – Configuration & Operation
Refresh: Click M to refresh the browser manually, or click 5s, 10s, or 30s to automatically refresh
the browser at 5, 10, or 30 second intervals.
IP Address: The IP address of the NetXpress LX shelf.
MAC Address: The Media Access Control address provided by the ARP.
Type: The type of addressing used.
Source Interface: The interface used to learn the entry in the ARP table.
Flush the ARP Table: Click
4.3.5

Configure Streams

You can use the Streams table (Figure 4-47) to add and configure packet streams in
the NetXpress LX system. You need to configure streams at all end points in the
network and instruct the NetXpress LX system to link portions of data among the
TDM busses, electrical ports, or IP destinations. The NetXpress LX system supports
up to 32 full-duplex streams. Streams cannot share the same source or destination
channels on one NetXpress LX system unless one of the streams is first placed out of
service. To access the table, click Streams.
Harris Corporation
Intraplex Products
NetXpress LX & CM-30 Installation & Operation Manual
Figure 4-46. Networking | ARP Table
to delete all ARP Table entries.
Version 1, September 2010
4-47