Snmp Community - Harris CM-30 Installation & Operation Manual

4 – Configuration & Operation NetXpress LX & CM-30 Installation & Operation Manual
Version 1, September 2010
5. After configuring the peer to this CM-30 module in another chassis, verify the current operational
status (up, down) of the primary timing source.
4.2.3.7

SNMP Community

You only need to perform this procedure if you use SNMP. Section 4.3.4.4 – SNMP Communities gives
more information. If you only use the CM-30 software, you do not need this procedure.
1. Point to Networking and click SNMP (Figure 4-15).
Figure 4-15. SNMP Configuration
2. Type the Read-only community name for read-only access.
3. Type the Read-write community name for read/write access.
4. Click Save.
4.2.3.8 Configuration Backup/Restore
You can operate the NetXpress LX multiplexer without performing this procedure. However, we
recommend you save your configuration files.
1. Point to System Cfg and click Configuration Backup (Figure 4-16).
Harris Corporation 4-13
Intraplex Products