Send Echo Requests; Configure Cm-30 Module - Harris CM-30 Installation & Operation Manual

4 – Configuration & Operation
Subnet mask: Type a subnet mask address for this IP address.
Close: Click this button to return to the IP Access List page without creating an entry or after
creating an entry.
Add Address: Click this button to create an address entry within the IP Access List.
4.3.8

Send Echo Requests

Host IP Address: Type the target (Host IP address) for the ping request.
Don't Route Past Local Network: Select this check box to limit the ping request to the local subnet
only.
Number of Packets: Type a number of echo requests (packet ping requests) to be sent or click the
arrows to increase or decrease the displayed number. The default value is 1.
PING Result: The result of the ping request (Got Response or No Response).
Send Ping: Click this button to execute the ping request.
4.3.9

Configure CM-30 Module

On the Home page of the NetXpress LX interface, click Open on the CM-30 module to access these
configuration pages:
● General
● Revisions
● Program Boot ROM
Click a tab to access that page.
4.3.9.1 CM-30 General Configuration
The General configuration page (Figure 4-70) allows you to view information for the CM-30 module
(such as IP and MAC addresses, serial number, and insertion date) and modify the board description.
Harris Corporation
Intraplex Products
You can send echo requests to a host IP address using the PING Utility page
(Figure 4-69). To access this page, point to Utilities and click Ping.
Figure 4-69. Ping Utility
NetXpress LX & CM-30 Installation & Operation Manual
Version 1, September 2010
4-73