Advertisement
Available languages
Available languages
Check Operation
Refer to the Use and Care Guide packaged with tile
range for operating instructions and for care and
cleaning of your range.
Do not touch the elements. They may be
hot enough to cause burns.
Remove all packaging from the oven and tile warmer
drawer (if equipped) before testing.
1.
Operation
of Surface Elements
Turn on each of the four surface elements and check to
see that they heat. Check the surface element indicator
light(s), if equipped.
2,
Operation
of Oven Elements
The oven is equipped with an electronic oven control. Each
of the functions has been factory checked before shipping.
However, it is suggested that you verify the operation of
the electronic: oven controls once more. Refer to the
Electronic Oven Control Guide for operation. Follow the
instructions for the Clock, Timer, Bake, Broil, Convection
(some models) and Clean functions.
Bake-After
setting the oven to 350°F (! 77°C) for baking,
the lower element in the oven should become red.
Broil-When
the oven is set to BROIL, the upper element
in the oven should become red.
Clean-When
the oven is set for a self-cleaning cycle, the
upper element should become red during the preheat
portion of the cycle. After reaching the self-cleaning
temperature,
the lower element will become red.
Convection
(some modeJs)-When
the oven is set to
CONV. BAKE/ROAST at 350°F (!77°C), the convection
element cycles on and off and the convection fan turns.
The convection fan will stop turning when the oven door
is opened during convection baking or roasting.
Warmer
Drawer (some mode[s)-Set
the control knob
to HI and check to see the drawer is heating.
Before
You Call for Service
Read tile Avoid Service Checklist and operating
instructions in your Use and Care Guide. It may save you
time and expense. The list includes common occurrences
that are not the result of defective workmanship or
materials in this appliance.
Refer to the warranty and service information
in your Use
and Care Guide for Sears phone number and address.
Please call or write if you have inquiries about your
range product and/or need to order parts.
Optionam Anti-Tip
Screws
(Lift4op Models Only)
Raise the lift-up cooktop and support it with cooktop
supprot rod. Drill I/8" (0.3 cm) diameter pilot holes into
countertop
using holes in upper side panels as a
template. Fasten the upper side panels to the countertop
with screws provided in a plastic bag in the oven.
When All Hookups
are Complete
Make sure all controls are left in the OFF position.
Model
and Serial Number
Location
The serial plate is located on the oven front frame
behind the oven door (some models or behind the
drawer (some models).
When ordering parts for or making inquiries about your
range, always be sure to include the model and serial
numbers and a lot number or letter from the serial plate
on your range.
Figure 9
Advertisement
