Advertisement
Available languages
Available languages
Figure9
Decorative
Rear Trim JnstaINation
(if required)
1.
Disconnect the power from the range.
2.
Make sure the range is leveled.
3.
Pull range toward you.
4.
Measure the distance between the floor and the
surface underneath tile cooktop frame.
5.
Mark that distance on tile wall where the decorative
trim will be installed.
6.
Draw a line.
7.
Place the top of the decorative trim under that line.
8.
Using the screws provided fix the decorative trim into
tile wall.
9.
Slide tile range back into position as far as it will go
and reconnect the power source.
Trim
Figure 10
Check Operation
Refer to the Use and Care Guide packaged with the
range for operating instructions and for care and
cleaning of your range.
Remove all packaging from the oven before testing.
11.1 install
Burner
Bases and Burner
Caps
This range is equipped
with
sealed
burners
as shown
(see Figure
11}.
a. Unpack burner bases and burner caps.
b. Place burner bases over each gas opening.
c. Make sure the burner is properly aligned and leveled.
Place burner caps over appropriate burner bases.
NOTE: There are no
burner adjustments
necessary on this range.
Eleotrod_-
Figure 11
11.2 Turn on Electrical
Power
and Open
Main Shutoff
Gas Valve
11.3 Check the Igniters
Operation of electric igniters should be checked after
range and supply line connectors have been carefully
checked for leaks, and range has been connected to
electric: power. To check for proper lighting:
a. Push in and turn a surface burner knob to tile LITE
position. You will hear tile igniter sparking.
b. The surface burner should light when gas is available
to the top burner. Each burner should light within four
(4) seconds after air has been purged from supply
lines. Visually check that burner has lit.
c. Once the burner lights, the control knob should be
rotated out of the LITE position.
There are separate ignition devices for each burner. Try
each knob separately until all burner valves have been
checked.
11,4
Adjust
the
"LOW"
Setting
of Surface
Burner
Valves
(see Figure
12)
a. Push in and turn each control to LITE until burner
ignites.
b. Quickly turn knob to LOWEST POSITION.
c. If burner goes out, readjust valve as follows:
Reset control to OFF. Remove the surface burner
control knob, insert a thin-bladed screw driver into
the hollow valve stem and engage the slotted screw
inside. Flame size can be increased or decreased with
the turn of the screw. Adjust flame until you can
quickly turn knob from LITE to LOWEST POSITION
without extinguishing
the flame. Flame
should be as small as
possible without
going out.
Figure 12
Advertisement
