Advertisement
Available languages
Available languages
ModeBsEquipped with LeveBin [g_
Toreduce the riskof tippingof the range,
therange mustbesecured t o thefloor byproperly
installed antPtip brackets a ndscrews packed w ith the
range. T hose parts arelocated ina plastic bagin the
oven. F ailure to install t he antPtipbrackets w ill allowthe
range to tip overif excessive weightisplaced onan
opendooror if a child(:limbs uponit. Serious i njury
mightresult f romspilled hotliquids or fromthe range
itself.
Follow theinstructions b elowto install t he antPtip
brackets.
If range isevermoved to a different l ocation, t he antPtip
brackets m ustalsobemoved andinstalled withthe
range. T ocheck for properinstallation, seestep5.
Tools
Required:
5/16" (0,79 cm) Nutdriver or Flat Head Screwdriver
Adjustable Wrench
Electric Drill
3/16"(0,5
cm) Diameter Drill Bit
3/16"(0,5
cm) Diameter Masonry Drill Bit (if installing in
concrete)
Brackets attach to the floor at the back of tile range to
hold both rear leg levelers. When fastening to the floor,
be sure that screws do not penetrate electrical wiring or
plumbing. The screws provided will work in either wood
or concrete.
1.
Unfold paper template and place it flat on the floor
with the back and side edges positioned exactly
where the back and sides of range will be located
when installed. (Use the diagram below to locate
brackets if template is not available. (figure !2))
2.
Mark on the floor the location of tile 4 mounting
holes shown on the template. For easier installation,
3/16" (0.5 cm) diameter pilot holes 1/2" (1.3 cm)
deep can be drilled into the floor.
3.
Remove template and place brackets on floor with
turned up flange to the front. Line up holes in
brackets with marks on floor and attach with 4
screws provided. Brackets must be secured to solid
floor. If attaching to concrete floor, first drill 3/16"
(0.5 cm) dia. pilot holes using a masonry drill bit.
4.
Level range if necessary, by adjusting 4 leg levelers
with wrench. (See Figure 13 below.)A
minimum
clearance of I/8" (0.8 cm) is required between the
bottom of the range and the rear leg levelers to
allow room for the anti4ip brackets.
5.
Slide range into place making sure rear legs are
trapped by ends of brackets. Range may need to be
shifted slightly to one side as it is being pushed back
to allow rear legs to align with brackets. You may
also grasp the top rear edge of the range and
carefully attempt to tilt it forward to make sure
range is properly anchored.
Back Edge of
!
Anti-Tip Bracket
Range or Rear Wall
:_A"Typ,
Pz" (13 crn)
(19 crn) Typ,
Anti-Tip Bracket
(495 cm)
f""
28 1/s"
/_(71
4 crn)
_(Rear
width of range
_with
body sides)
Figure 13
Figure 12
Slide Back
10
Advertisement
