Level Dryer; Complete Installation Checklist - Kenmore 29" Installation Instructions Manual

If dryer is not level, prop up using a wood block, use wrench to adjust
legs up or down, and check again for levelness. Once legs are level,
make sure all four legs are snug against the floor.
Move dryer to final location. Avoid crushing or kinking vent. After dryer
is in place, remove cardboard from under the dryer.
LEVEL DRYER
1. Level Dryer
Place Level Here Place Level Here
Check levelness of dryer from side to side. Repeat from front to back.
NOTE: The dryer must be level for the moisture sensing system to operate
correctly.
Not Level LEVEL Not Level
COMPLETE iNSTALLATiON
CHECKLIST
[_ Check that all parts are now installed. If there is an extra part,
go back through steps to see what was skipped.
[_ Check that you have all of your tools.
[_ Dispose of/recycle all packaging materials.
[_ Check dryer's final location. Be sure vent is not crushed or kinked.
[_ Check that dryer is level. See "Level Dryer."
[_ Remove film on console and any tape remaining on dryer.
[_ Wipe dryer drum interior thoroughly with a damp cloth to remove
any dust.
[_ Read "Dryer Use" in your "Use and Care Guide."
[_ Set the dryer on a full heat cycle (not an air cycle) for 20 minutes
and start the dryer.
if the dryer will not start, check the following:
[] Controls are set in a running or "On" position.
[] Start button has been pushed firmly.
[] Dryer is plugged into an outlet and/or electrical supply is on.
[] Household fuse is intact and tight, or circuit breaker has not
tripped.
[] Dryer door is closed.
[_ When the dryer has been running for 5 minutes, open the dryer door
and feel for heat. If you feel heat, cancel cycle and close the door.
if you do not feel heat, turn off dryer, and check the followlng:
[] There may be 2 household fuses or circuit breakers for the dryer.
Check that both fuses are intact and tight, or that both circuit
breakers have not tripped. If there is still no heat, contact a
qualified technician.
NOTE: You may notice an odor when the dryer is first heated. This odor is
common when the heating element is first used. The odor will go away.
16