Table of Contents
Advertisement
USING THE KEYPAD TO SELECT A SOUND
Each WK4 Sound is identified by two numbers:
the ProgramChange (PC) and the BankSelect
MSB number, or ControlChange 00 (CC00). You
can select a Sound by specifying the absolute
values corresponding to the PC and CC num-
bers on the numeric keypad.
In MIDI setups, a third number corresponding to
the BankSelect LSB, or ControlChange 32 (CC32),
is sometimes necessary to select a sound of an
expander connected to the WK4 MIDI OUT.
Note: If you specify the ProgramChange on its
own, the bank rests unchanged. For example, if
the current Sound is 112-2-1, by specifying
ProgramChange 96 or sending PC96 via MIDI, you
will select Sound 96-2-1.
1. Select the track to which the Sound is to be as-
signed.
2. Press the KEY PAD button to enable the numeric
keypad.
An insertion window activates showing the
number of Sound currently assigned to the
track.
3. Specify the ProgramChange of the required
Sound.
If the Sound belongs to a different Bank, key
in a dash («–») which acts as a separator
then specify the corresponding Bank number
(Bank Select MSB).
If necessary, add a second separator («–»)
and the third part of the message (BankSelect
LSB).
4. Confirm by pressing KEY PAD or ENTER, or press
ESCAPE to cancel the operation.
The KEY PAD LED will go off.
Press STORE PERF then ENTER to save
the change.
4•8 User Guide
1
2
3
4
Advertisement
Table of Contents
