Table of Contents
Advertisement
SAVE SINGLE SONG
Use «Save Single Song» to save Songs to disk
one at a time. If you have already loaded some
MIDI Files to RAM, use this procedure to convert
the files to WK4 format songs.
1. Select SINGLE SONG from the main Save page
and press ENTER to gain access to the FILE SE-
LECTOR.
2. Select the destination device (Floppy or Hard
disk).
Press soft button F1 to select the Floppy disk.
Press soft button F2 to select the Hard disk.
3. Select a destination Block then press ENTER to
gain access.
If necessary, select an empty location to cre-
ate a new Block (refer to the General Save
procedure for specific details about how to
create a new block).
4. Select the Song from the RAM directory and its
destination in disk then press ENTER twice to
execute the command.
If you save to an existing Song, it will be
overwritten by the incoming song.
If possible, save to an empty location (shown
as a broken line).
Hint: A Block can hold up to 16 Songs divided
into two virtual groups. If no empty locations are
shown, it means that the block is fully occupied. In
this case, either overwrite an existing Song that
you don't mind losing, or close the Block with
ESCAPE, then select an empty location and press
ENTER to create a new Block.
1
2
3
4
Disk 6•25
Advertisement
Table of Contents
