Download Print this page

Advertisement

Quick Links

SERVICE MANUAL
Index
6
8
2nd Edition
Warnings
Address
L CODE: 270215 M
2
Opening, Keyboard Disassembling Instructions and Autotest Procedure
3
Assembly & Wiring Connections
4
Assembly & Layout
5
Timing Table
6
Block Diagram, Midi & Controls I/O and Keyboard Int. Pcb Layouts
7
Midi & Controls I/O, Keyboard Interface & L/R Contact Schematics
8
Power Amplifier & Supply Schematic, Adjustment Table
9
Power Amplifier & Supply, Phones & Trackball Pcb Layouts
10
Controls Panel, Trackball & Dc-Ac Converter Schematics
11
Controls Panel Pcb Layout & Reverse Layout
12
Cpu & Sound Generator Schematic (Part 1/2)
13
Cpu & Sound Generator Schematic (Part 2/2)
14
Cpu & Sound Generator Pcb Layout
15
Cpu & Sound Generator Map
16
A/V & Vocal Processor Pcb Layouts
17
A/V & Vocal Processor Schematic
18
Spare Part List
Notice
Service must be carried out by qualified personnel only.Any tampering carried out by unqualified personnel during the guarantee period
will forfeit the right to guarantee.
For a correct operation of the instrument, after having switched off, be careful to wait at least 3 seconds before switching on again.
To improve the device's specifications, the schematic diagrams may be subject to change without prior notice.
All components marked by this symbol have special safety characteristics, when replacing any of these components use only
manufacturer's specified parts.
The (µ) micro symbol of capacitance value is substituted by U.
The (Ω) omega symbol of resistance value is substituted by E.
The electrolytic capacitors are 25Vdc rated voltage unless otherwise specified.
All resistors are 1/8Ω unless otherwise specified.
All switches shown in the "OFF" position. All DC voltages measured to ground with a voltmeter 20KOhm/V.
Soldering point.
Supply voltage.
Male connector.
Test point.
Female connector.
Flag joined with one or more flags
M/F faston connector.
with the same signal name inscribed.
ATTENTION
Observe precautions when handling electrostatic sensitive devices.
GENERALMUSIC S.p.A. Sales Division: 47842 S.Giovanni in Marignano (RN) ITALY - Via delle Rose, 12 - tel. 0541/959511 - fax 0541/957404
GENERALMUSIC on the NET: http://www.generalmusic.com
Logic supply ground.
Analog supply ground.
Chassis ground.
Earth ground.
1 1 1 1 1 ❏ ❏ ❏ ❏ ❏

Advertisement

loading
Need help?

Need help?

Do you have a question about the WK 6 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for General Music WK 6

  • Page 1 Index Opening, Keyboard Disassembling Instructions and Autotest Procedure Assembly & Wiring Connections Assembly & Layout Timing Table Block Diagram, Midi & Controls I/O and Keyboard Int. Pcb Layouts Midi & Controls I/O, Keyboard Interface & L/R Contact Schematics Power Amplifier & Supply Schematic, Adjustment Table Power Amplifier &...
  • Page 2: Autotest Procedure

    Opening Instructions refer to fig. 1 Fig. 1 To open the instrument remove the screws marked by To separate the keyboard from chassis remove the screws marked by (open the instrument before proceed) To access to the Disk Drive remove the screws marked by Keyboard Disassembling Instructions Keyboard Exploded View Autotest Procedure...
  • Page 3 For descriptions and codes see the correspondance on reference column (REF) in the PART LIST above. LCD ADJ AFT ADJ GENERALMUSIC S.p.A. ITALY 3 3 3 3 3 ❏ ❏ ❏ ❏ ❏...
  • Page 4 550143 GENERALMUSIC S.p.A. ITALY Boccato DWG# PCB# ALL RIGHTS ARE RESERVED, NO COPIES Boccato DISK: PART: LAYOUT OR REPRODUCE THIS DOCUMENT WITHOUT WRITTEN CONSENT BY GENERALMUSIC. APP. Falconi REV: 30/06/98 ❏ ❏ ❏ ❏ ❏ 4 4 4 4 4...
  • Page 5 5 5 5 5 5 ❏ ❏ ❏ ❏ ❏...
  • Page 6 KEYBOARD INTERFACE BOARD (PCB LAYOUT). MIDI & CONTROLS I/O BOARD (PCB LAYOUT). GENERALMUSIC S.p.A. Italy DWG: 315024/088 DRW: BOCCATO SCHEMATIC DIAGRAM WK6 / WK8 550145 GENERALMUSIC S.p.A. ITALY G. Boccato DWG# PCB# Midi & Controls I/O Board, Keyboard ALL RIGHTS ARE RESERVED, NO COPIES OR CKD: RICCOBELLI DISK: 4 PART: 1/1 WK6-8 BLOCK DIAGRAM...
  • Page 7 7 7 7 7 7 ❏ ❏ ❏ ❏ ❏...
  • Page 8 ❏ ❏ ❏ ❏ ❏ 8 8 8 8 8...
  • Page 9 PHONES BOARD BOARD (PCB LAYOUT) TRACKBALL BOARD (PCB LAYOUT) DWG: 315085/1 GENERALMUSIC S.p.A. Italy POWER AMPLIFIER & SUPPLY BOARD (PCB LAYOUT) DRW: BOCCATO SCHEMATIC DIAGRAM WK6 / WK8 315095-096 Phones, Tackball and Power Amp. & ALL RIGHTS ARE RESERVED, NO COPIES CKD: RICCOBELLI DISK: 4 PART: 1/1 OR REPRODUCE THIS DOCUMENT WITHOUT...
  • Page 10 ❏ ❏ ❏ ❏ ❏ 10 10 10 10 10...
  • Page 11 CONTROLS PANEL BOARD (PCB REVERSE LAYOUT) GENERALMUSIC S.p.A. Italy CONTROLS PANEL BOARD (PCB LAYOUT) DWG: 315084 DRW: BOCCATO SCHEMATIC DIAGRAM WK6 / WK8 Controls Panel Board (Pcb Layout and ALL RIGHTS ARE RESERVED, NO COPIES CKD: RICCOBELLI DISK: 4 PART: 1/1 OR REPRODUCE THIS DOCUMENT WITHOUT Reverse Layout) WRITTEN CONSENT BY GENERALMUSIC.
  • Page 12 ❏ ❏ ❏ ❏ ❏ 12 12 12 12 12...
  • Page 13 13 13 13 13 13 ❏ ❏ ❏ ❏ ❏...
  • Page 14 CPU & SOUND GENERATOR BOARD (PCB LAYOUT). GENERALMUSIC S.p.A. Italy DWG: 315083 DRW: BOCCATO SCHEMATIC DIAGRAM WK6 / WK8 Cpu & Sound Generator Board (Pcb ALL RIGHTS ARE RESERVED, NO COPIES CKD: RICCOBELLI DISK: 4 PART: 1/1 OR REPRODUCE THIS DOCUMENT WITHOUT Layout) WRITTEN CONSENT BY GENERALMUSIC.
  • Page 15 J1 - Set the jumper as follow: J2 - Set this jumper as follow: 1-2 "A" if Buffer modules are installed CN2 - to Controls Panel Board CN3 - to MIDI I/O Board 1-2 for 8MB SAMPLE DRAM expansion 2-3 "B" if SIMM DRAM modules are installed 2-3 for 2MB SAMPLE DRAM expansion note: the buffer modules are supplied if no DRAM expansion is installed...
  • Page 16 A/V & VOCAL PROCESSOR BOARD (PCB LAYOUT) GENERALMUSIC S.p.A. Italy DWG: 315109 DRW: BOCCATO SCHEMATIC DIAGRAM WK6 / WK8 Audio/Video Interface Board (Pcb Layout) ALL RIGHTS ARE RESERVED, NO COPIES CKD: RICCOBELLI DISK: 4 PART: 1/1 OR REPRODUCE THIS DOCUMENT WITHOUT WRITTEN CONSENT BY GENERALMUSIC.
  • Page 17 CPU DATA BUS IC18-A GATEVIDEO 761143 - AUDIO/VIDEO WITH VOCAL PROCESSOR BOARD (PAL VERSION) IC16-A HM514260 MAD0 MAD1 761152 - AUDIO/VIDEO WITH VOCAL PROCESSOR BOARD (NTSC VERSION) AR11 33E X4 MAD2 MAD3 MAD4 MAD5 AR10 33E X4 MAD6 MAD7 MAD8 R34 100E MD10 +5VB...
  • Page 18 40 652745 Potentiometers Display Rubber Strip 071011 2x10K Alog Rotary Pot 28 761093 Buffer Module Board (Pcb# 315023) (WK8) Spare Part List Controls & Midi I/O Board 41 652746 <Sound Groups> Actuators Rubber Strip 070181 10K 20% Horizontal Linear Trimmer 103013 74HC138D SOIC 1 Of 8 Decoder Legend...

This manual is also suitable for:

Wk 8