Table of Contents
Advertisement
Locator (Song position pointer)
This section shows the current Song position
expressed in measures and beats. When the
Song is not playing, the Locator can be modified
in the «Play View» page in order to select a start-
ing point for the playback. It can be also modi-
fied with the [<<] and [>>] buttons regardless of
the status of the sequencer (playing or off).
measure
Locator (programmable)
Repeats the same information of the locator
shown in the status bar, but also contains the
sequencer resolution (or 'tick').
When the sequencer is off, the three parts can
be individually modified (if selected) by rotating
the DIAL.
measure
Play/Rec mode
There are three Play or Record options to choose
from:
•
Linear
The Song starts at the point indicated by the
locator and stops at the natural Song end.
7•8 User Guide
beat
beat
resolution (tick)
•
Forced stop
The Song starts at the point indicated by the
locator and stops at the specified End.
•
Loop
The Song starts at the point indicated by the
locator, stops at the End, then repeats from
the Starting point. The loop repeats continu-
ously until stopped with the Stop button.
Start
Determines the start measure and can be modi-
fied only if the Play mode is set to «Loop». If
Loop is selected, this parameter indicates the
starting point of the loop. Modify this parameter
when it is in a selected state, or when the Song
has already been recorded, by rotating the DIAL.
End
Determines the end measure and can be modi-
fied only if the Play mode is set to «Forced stop»
or «Loop». If Loop is selected, this parameter
indicates the point at which the sequence ends
before looping back to the Start locator. If Forced
stop is selected, it indicates the automatic Stop
point.
This parameter can be modified when it is in a
selected state by rotating the DIAL.
Advertisement
Table of Contents
