Table of Contents
Advertisement
RECORDING
1. Press START/STOP to start the recording. A
one-measure countdown with start.
2. Start playing after the lead-in. The recording
proceeds in a cyclic manner: once the end of
the riff is reached, the recording starts again
from the beginning..
3. Stop the recording with START/STOP.
4. To add notes to the same tracks, repeat points
1 - 3.
Note: If the Overdub recording mode is
selected, new notes will be added to the tracks
each time the recording repeats. If Replace is
selected, new notes will cancel those already
existing on the next cycle. In Replace mode, the
recording returns to Overdub mode at the end of
the first cycle.
5. Select the tracks shown in «record» and set
them in «seq-play».
6. If necessary, repeat the procedure for other
tracks.
7. Press RECORD to escape «Record» mode.
The LED on the RECORD button goes off.
UNDO
If, during the recording phase, you want to can-
cel the last performed recording task, use UNDO
to cancel the last performed task.
For example, after adding new events to an ex-
isting drum pattern, you might want to return to
the original pattern and just cancel the new
events. A quick and easy way is to use UNDO.
Just press UNDO and confirm with ENTER to
return to the previous status, or ESCAPE to re-
tain the last task.
12•4 Reference Guide
RESTORING THE USER STYLES MEMORY
If you have loaded disk-based Style or recorded
User Styles and used up all the memory dedi-
cated to the storage of Styles, a quick and easy
way of clearing User Style memory and making
room for other Styles is to use the Restore Styles
operation.
Naturally, you must remember to save the User
Style that you don't want to lose to disk before
proceeding with the restore procedure.
1. Press GENERAL in the EDIT section to gain
access to the «Edit General» environment.
2. Press F5 («Restore Styles») to cancel all the
User Styles (and relative User Style-Presets)
in RAM.
You are prompted with a request to recon-
firm your choice.
3. Press ENTER to confirm, or ESCAPE to can-
cel.
With ENTER, the User Styles are cancelled
from memory.
With ESCAPE, the User Styles are retained.
Hint: To cancel the entire contents of RAM in a
single operation, use the «Restore All» command.
Advertisement
Table of Contents
