Table of Contents
Advertisement
7. If necessary, select the source file.
Use the /
buttons to select the source
file from the active column. If you are not in
the desired column, move over with the /
buttons.
8. If necessary, select the destination.
Move into the destination column with the /
buttons and use the /
a destination.
Empty locations are identified by a broken
line. If you select an existing file, it will be
erased by the incoming file.
9. Press ENTER to confirm your choice.
You will be prompted with "Are you sure?".
10. Press ENTER again to execute the command, or
ESCAPE to cancel the operation.
With ENTER, the command is executed and
a dialog window opens showing a message
relating to the current operation: For exam-
ple, if you are loading a single Song, the
message will say: "Loading Single Song...."
When the dialog window closes, the opera-
tion has been executed..
11. Repeat steps 7, 8, 9 and 10 until your destina-
tion is organized according to your requirements.
To select another file from a different block,
return to the source column, press Escape
to escape the current Block, press Escape
again to exit the File Selector, select another
Block, press Enter to gain access and con-
tinue as already described.
12. Press DISK (or ESCAPE three times) to exit «Disk».
Pressing DISK escapes the Disk operations
and remembers the last page selected.
Pressing ESCAPE allows you to (1) close the
current Block, (2) close the file selector and
(3) escape from «Disk».
buttons to select
7/8
9
10
11/12
or
Disk 6•7
Advertisement
Table of Contents
