Attach The Rear Fenders - Schwinn Meridian Owner's Manual

Attach the Rear Fenders

Parts: Rear Fenders, rear frame
Tools: Phillips Head screwdriver or 10mm box wrench
(minimum 4" shaft)
Hardware: 3 small screws
The hardware comes attached to the frame . Remove
the hardware before you begin this procedure .
1 . Position the fender so the rear reflector is facing away
from the bike .
2 . Align the slots on the fender tabs with the slots on the
rear frame tabs . Note: The tabs on the fender should be
on the outside of the tabs on the rear frame tabs .
3 . Working from the inside of the wheel, fasten 2 screws
through the side holes of the fender tab into the rear
frame tabs . Do not tighten securely .
4 . Rotate the rear wheel until there is adequate space for
the Phillips Head screwdriver or 10mm wrench to reach
through the spokes to the center fender hole . Attach
screw but do not tighten securely .
5 . Pull the fender upwards away from the tire to make sure
the tire has proper clearance . Securely tighten the 3 bolts
to hold the fender in place .
27
Schwinn Meridian Manual R3 0918112 .indd 27
6 . Repeat steps 1-5 for the second fender .
1
2
3
4
5
6
9/18/12 3:44 PM