Attach The Rear Fenders - Schwinn 26” User Manual

Attach the Rear Fenders

Parts: Rear Fenders, rear frame
Tools: Phillips Head screwdriver (minimum 4" shaft)
Hardware: 4 nuts, 4 screws, 8 washers The hardware
comes attached to the frame . Remove the
hardware before you begin this procedure .
1 . Position the fender so the rear reflector is facing
away from the bike.
2 . Rotate the rear wheel until there is adequate space
for the Phillips Head screwdriver to reach through
the spokes to the fender slots.
3 . Align the slots on the fender with the slots on the
rear frame.
4 . Insert a washer onto a screw.
5 . Insert the washer and screw through the aligned slots.
6 . Insert a washer and nut on the end of the screw.
7 . Hold the nut with the pliers, and tighten the screw,
but not completely .
Note: Be sure that the fender has adequate clearance
from the wheels. It may be necessary to adjust the
fender slightly to properly align with the wheels.
8 . Repeat steps one through six for the second slot.
9 . Firmly tighten both screws.
10. Repeat steps one through nine for the second fender.
3
1
5
2
4
6
28