Advertisement
Welcome!
Congratulations on your purchase of the two (2) fibers DisplayPort extender,
DPFX-100-TR. This manual contains information that will assist you in
installing and operating the product.
Product Description
New compact optical DisplayPort extender, DPFX-100-TR enables to transmit
WQXGA (2560x1600) at 60Hz signal up to 300m (985feet), avoiding any tricks
like scaling or data compression for lessening a burden of data transmission.
It provides total data throughput 10.8Gbps (2.7Gbps per lane).
The pure fiber connection by two (2) LC fibers connector between transmitter
and receiver, gives clean, secure and easy installation with perfect electrical
isolation, but without electrical hazard and interference. The DPFX-100-TR can
be operated by both USB power by plugging the USB cable and DC power
included as a shipping group.
Figure 1 – Overall Connection of DPFX-100-TR
The Shipping Group of DPFX-100-TR;
One (1) Transmitter (Tx) and One (1) Receiver (Rx)
Two (2) DP copper cables (0.5m)
Two (2) USB to DP plug Cables
Two (2) DC +5V,1A power adapters
User's Manual
Option Product: LC Multi-mode fiber
1-1 Welcome, Product Description
System Requirements for Setup
□
Hardware requirements
▪
You have to have a DisplayPort source and display. It should
support the maximum graphic resolution feature of displays to
be connected.
▪
No special requirements of memory size, CPU speed and
chipsets, if you've already properly installed your DisplayPort
systems or graphic cards.
▪
Proper initial trial of the entire platform with its application using
a short length copper cable is recommended prior to install with
the optical link.
□
Software requirements
No special restrictions, if you've already properly installed your
▪
Displayport systems.
Power Technical Advisory
□
▪
Enclosed Power Adaptors and USB cables supply power to both
Transmitter and Receiver.
□
Connection Advisory
▪
It is highly recommend that DisplayPort source is directly
connected into DisplayPort display output via DPFX-100-TR
without connection to incompatible distributor, switcher and
selector.
1-2 System Requirements for Setup
Advertisement
