Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Energic Plus SMC
Summary of Contents for Energic Plus SMC
- Page 1 SMC BATTERY CHARGER USER’S MANUAL USER’S MANUAL...
-
Page 2: Table Of Contents
2.2 GLOSSARY............................2 2.3 DATA LABEL............................2 2.4 HOW TO USE THE USER'S MANUAL....................2 2.5 RESPONSIBILITY DISCLAIMER......................3 3 SMC BATTERY CHARGER – DESCRIPTION..............3 3.1 SMC BATTERY CHARGER – INTRODUCTION................... 3 3.2 TECHNICAL DATA..........................3 3.2.1 PHYSICAL FEATURES........................3 3.2.2 TECHNICAL DESCRIPTION ...................... -
Page 3: Introduction
The code and the version of this manual are written on the bottom of each page. If you need more copies please specify Code and Version. Before starting to use your ENERGIC Plus SMC battery charger please read these instructions carefully. GLOSSARY... -
Page 4: Responsibility Disclaimer
SMC BATTERY CHARGER USER’S MANUAL RESPONSIBILITY DISCLAIMER The manufacturer of ENERGIC Plus SMC battery chargers will not be responsible for damages caused by the chargers in these situations: The charger is not installed properly by a qualified electrician; The charger is not used according to the instructions included in this manual;... -
Page 5: Installation Of The Charger
ENERGIC Plus SMC battery chargers are equipped with a relay that can be used to block the vehicle motor when the charger is connect to the main supply and the main switch is ON. This safety function will prevent the user to start the vehicle while it's being charged. -
Page 6: Main Supply Voltage Preset
(see chapter 5.3.1). Attention: ENERGIC Plus SMC chargers are programmed to do a complete cycle of charge, however it’s recommended to survey the operations when the battery must remain connected to the charger for more than 12 hours (example: week-... -
Page 7: Charge Cycle
Before disconnecting the battery, check it is not being charged. If it is charging (led “CHARGE ON” light on), turn off the charger using the main switch , to avoid sparks between connectors. Code: SMC-TVH Version: 01 Date: 24/08/2005 Page 6 of 7... -
Page 8: Emergency Stop
Check the connections between main supply and charger; Verify that the power available on the main supply is sufficient for the charger; TECHNICAL DOCUMENTS This manual includes the following technical documents: ELECTRIC DIAGRAM Code: SMC-TVH Version: 01 Date: 24/08/2005 Page 7 of 7...
Need help?
Do you have a question about the SMC and is the answer not in the manual?
Questions and answers