Table of Contents
Advertisement
Introduction
(For USA and Europe)
The unit is to be powered by a DC 12 V or an AC 24 V power supply.
The unit is to be powered by a UL Listed DC 12 V or an AC 24 V
power supply. (For USA)
The AC 24 V and 12 V DC power supply shall conform to the
following: Class 2 only (For USA), Isolated power supply only (For
Europe).
This installation should be made by a qualified service person and
should conform to all local codes.
This installation shall be in accordance with the National Electrical
Code, ANSI/NFPA 70.
Any Mention in this manual of Alarm inputs have not been evaluated
by UL to be used for Burglar Alarm Functionality.
Special technique is required when installing this product. Please
refer to your dealer for installation.
Rating label is pasted on of the camera unit.
JVC KENWOOD Corporation is not liable for any compensation if you
drop the camera due to insecure mounting by not following the
installation description. Pay careful attention during installation.
When mounting this product to a ceiling or wall, select a location
strong enough to support the weight of this camera. If the location is
not strong enough to support the weight, be sure to reinforce the
ceiling or wall before installation.
The camera may drop if the mounting screws are not tightened
securely. Check that the screws are tightened appropriately and
securely.
Do not install the camera near lighting fixtures of high temperature,
such as spot lights. It might result in failure or fires.
Do not step on or hang on the camera. Doing so may cause the
camera to fall, and break, which would cause injuries.
E-9
Advertisement
Table of Contents
