JVC TK-C2301WPRU Instructions Manual page 32

Installation
Mounting the Camera (Continued)
Mounting the Camera Using the Conduit Hole at the Side of the
Base
If the camera cannot be mounted directly to the ceiling, use the conduit
hole at the side of the base to mount the camera to the pipe.
Conduit hole: G3/4-14 UNC (TK-C2301WPRU), M25 (TK-C2301WPRE)
1 Remove the dome cover and inner dome (A page 23)
2 Remove the camera unit from the base and mount the fall
prevention wire to the camera unit
Refer to "Mounting the Camera Using the Conduit Hole at the Bottom of
the Base" (A page 30) step 2.
3 Wind the sealing tape
Wind the sealing tape around the pipe junction (where the conduit hole
thread lines with the pipe screw hole) two or more times.
4 Remove the conduit plug from the base
Loosen the mounting screw (M3 x 6 mm) using a flathead screwdriver
and remove the conduit plug at the side of the base.
5 Mount the conduit plug that was removed to the conduit hole at
the bottom of the base
6 Mount the base to the pipe
Screw the pipe to the conduit hole at the side of the base.
When screwing the pipe, do not screw beyond 12 mm. Doing
Note
so can damage the camera interior.
Conduit plug
.
7 Refer to "Mounting the Camera Using the Conduit Hole at the
Bottom of the Base" (A page 30) step 6 to 9
E-32
Mounting screw
Sealing tape