JVC VN-C655 Instructions Manual page 37

Alarm Output
Item
7
Output1/
Output2
Output Value
Pattern
Interval
8
Output1 force
output/
Output2 force
output
Function & Setting
Enable this function to output alarm signals to the [ALARM
OUTPUT1] or [ALARM OUTPUT2] terminal.
For selecting the alarm output method.
Output OFF : Output alarm signals when the AlarmOut1
or AlarmOut2 terminal is connected to the
GND terminal.
Output ON : Output alarm signals when the AlarmOut1
or AlarmOut2 and the GND terminal are
disconnected from each other.
Level : Continue output of alarm signals through-
out the alarm input process.
Momentum : Output alarm signals only at the specified
time. Specify the time using the Interval
item.
For setting the output time when the Pattern item is set to
Momentum. This is disabled when the Pattern item is set to
Level.
If [Output] is pressed, alarm signals are sent to the [ALARM
OUTPUT1] or [ALARM OUTPUT2] terminal. This forced
output is used for checking the alarm function.
Initial Value
OFF
Output OFF
Level
100ms
—
37