Table of Contents
Advertisement
Preparations
Preparation Procedure
Set the camera in the following procedure.
Step 1 Connection and Installation
Attach a lens and connect the power cable, a LAN cable and an alarm etc.
Then, install the camera to a fixer, etc. Fix a wire securely for preventing the
camera from falling off.
Step 2 Setting the Network
Install the software [V.Networks Controller], and set the network for the PC
and VN-C10. Also perform the setting with [V.Networks Setup Tool] and regis-
tration of the connected camera with [V.Networks Controller].
❈ If multiple PCs are in use, first turn on the power for one PC and proceed to 2-4
Other Settings with V.Networks Setup Tool. Only then, turn on the power to a sec-
ond PC and go on to 2-4. Repeat the procedure for other PCs.
Step 3 Adjusting the Camera
Adjust the back-focus while checking images.
Step 4 Setting with V.Networks Controller
Set image quality and alarm, etc. by using [V.Networks Controller] which has
been installed.
Step 5 Operations with V.Networks Controller
Now the camera is ready for recording and playback, etc. with [V.Networks
Controller].
Step 6 Operations with a Web Browser
The camera is ready for Web operations.
12
☞
Page 13
☞
Page 19
(☞
Page 14)
☞
Page 43
☞
Page 44
☞
Page 55
☞
Page 61
Advertisement
Table of Contents
