Preparation Procedure; Step 1 Connection And Installation - JVC VN-C10U - Network Camera User Manual

Preparation Procedure

Set the camera in the following procedure.

Step 1 Connection and Installation

Attach a lens and connect the power cable, a LAN cable and an alarm etc.
Then, install the camera to a fixer, etc. Fix a wire securely for preventing the
camera from falling off.
Step 2 Setting the Network
Install the software [V.Networks Controller], and set the network for the PC
and VN-C10. Also perform the setting with [V.Networks Setup Tool] and regis-
tration of the connected camera with [V.Networks Controller].
❈ If multiple PCs are in use, first turn on the power for one PC and proceed to Other
Settings with V.Networks Setup Tool. Only then, turn on the power to a second PC
and go on to Other Settings with V.Networks Setup Tool. Repeat the procedure for
other PCs. Refer to the PDF instruction manual inside the supplied CD-ROM.
Step 3 Adjusting the Camera
Adjust the back-focus while checking images.
Step 4 Setting with V.Networks Controller
Set image quality and alarm, etc. by using [V.Networks Controller] which has
been installed.
Step 5 Operations with V.Networks Controller
Now the camera is ready for recording and playback, etc. with [V.Networks
Controller].
Step 6 Operations with a Web Browser
The camera is ready for Web operations.
☞
Page 12
☞
Page 16
☞
Page 24
☞
Page 25
☞
Page 27
☞
Page 28
11