Clearances; Assembly; Gas Connection - Blue Seal Evolution GP514 Installation And Operation Manual

Installation

Clearances

NOTE: Only non-combustible materials can be used in close proximity to this appliance.
Left / Right Hand Side
Rear

Assembly

NOTE:
 All Models are delivered completely assembled. No further assembly is required.
 This appliance is fitted with adjustable feet to enable appliance to be positioned
securely and level. This should be carried out on completion of gas connection. Refer to
'Gas Connection' section.
Optional Accessories (Refer to Replacement Parts List)
 Plinth Kit. For installation details, refer to instructions supplied with each kit.

Gas Connection

NOTE: ALL GAS FITTING MUST ONLY BE CARRIED OUT BY A QUALIFIED PERSON.
1. Blue Seal Gas Griddles do not require an electrical connection, as they function totally on gas supply
only.
2. It is essential that gas supply is correct for appliance to be installed and that adequate supply
pressure and volume is available. The following checks should be made before installation:-
a. Gas Type the appliance has been supplied for is shown on
coloured stickers located above gas connection and on
rating plate. Check this is correct for gas supply appliance is
being installed for. Gas conversion procedure is detailed in
this manual.
b. Supply Pressure required for this appliance is shown in
'Specifications' section of this manual. Check gas supply to
ensure adequate supply pressure exists.
c. Input Rate of this appliance is shown on Rating Plate, refer
to 'Dimensions' section for rating plate locations for different
models. Input rate should be checked against available gas
supply line capacity. Particular note should be taken if
appliance is being added to an existing installation.
NOTE: It is important that adequately sized piping runs directly to connection joint on appliance
with as few tees and elbows as possible to give maximum supply volume.
3. Fit gas regulator supplied, into gas supply line as close to appliance as possible.
NOTE:
 Measure burner operating pressure at gas valve outlet test point with burner operating at
'High Flame' setting.
 NAT, LPG & Butane Only - Operating pressure is ex-factory set, through the appliance
regulator and not to be adjusted, apart from when converting between gases, if required.
 TOWN GAS Only - Burner operating pressure is to be adjusted using Town Gas adjustable
gas regulator supplied.
 Refer to 'Gas Conversion and Specifications section in this manual for further details.
 (*) - GP514 Town Gas model is available ex-factory on request only.
Combustible Surface
50mm
50mm
10
Non Combustible Surface
0mm
0mm
Rating Plate
Location for Leg
Stand Models
Fig 1