Gas Supply Requirements; Gas Connection - Blue Seal Evolution GP514 Installation And Operation Manual

Specifications

Gas Supply Requirements

Natural Gas
GP514
Input
Rating 53 MJ/hr
(50,234 BTU)
(N.H.G.C.)
Supply 1.13 - 3.40 kPa
Pressure (4.5" - 13.5" w.c.)
Operating 0.85 kPa (*)
Pressure (3.4" w.c.)
Gas
Connection
(*) NOTE:
 Measure burner operating pressure at gas valve outlet test point with burner operating at
'High Flame' setting.
 NAT, LPG & Butane Only - Operating pressure is ex-factory set, through the appliance reg-
ulator and not to be adjusted, apart from when converting between gases, if required.
 TOWN GAS Only - Burner operating pressure is to be adjusted using Town Gas adjustable
gas regulator supplied.
 Refer to 'Gas Conversion and Specifications section in this manual for further details.
 (*) - GP514 Town Gas model is available ex-factory on request only.

Gas Connection

Bench Models
Gas supply connection point is located at rear of appliance, approximately 130mm from right hand
side, 32mm from rear, 55mm from floor and is reached from rear of appliance. (Refer to
'Dimensions' section).
Connection is ¾" BSP male (For all other models).
All Other Models
Gas supply connection point is located at rear of appliance, approximately 130mm from right hand
side, 32mm from rear, 655mm from floor and is reached from beneath appliance. (Refer to
'Dimensions' section).
Connection is ¾" BSP male (For all other models).
For Refrigeration Cabinet Specifications refer to Refrigeration Cabinet Installation and Operation
Manual supplied with appliance.
GP516 GP518 GP514
80 MJ/hr 108 MJ/hr 53 MJ/hr
(75,825 BTU) (102,364 BTU) (50,234 BTU)
0.90 kPa 2.5 kPa
(3.6"w.c.) (9.8" w.c.)
LP Gas / Butane
GP516 GP518
80 MJ/hr 108 MJ/hr
(75,825 BTU) (102,364 BTU)
2.75 - 4.50 kPa
(11" - 18" w.c.)
2.6 kPa
(10.2" w.c.)
¾" BSP Male
4
Town Gas
GP514 GP516 GP518
53 MJ/hr 80 MJ/hr 108 MJ/hr
(50,234 BTU) (75,825 BTU) (102,364 BTU)
0.75 - 1.50 kPa
(3" - 6" w.c.)
0.35 kPa 0.45 kPa
(1.4"w.c.) (1.8"w.c.)