To Use Digital Channels To View A Signal - Agilent Technologies 54621A User Manual

To use digital channels to view a signal

• To configure the oscilloscope quickly, press the
the connected signals.
• To undo the effects of Autoscale, press the
pressing any other key.
This is useful if you have unintentionally pressed the Autoscale key or do not
like the settings Autoscale has selected and want to return to your previous
settings.
• To set the instrument to the factory-default configuration, press the
Save/Recall
Example Install probe clips on channels 0 and 1 on the digital probe cable. Connect the
probes for digital channels 0 and 1 to the Probe Comp output on the front panel
of the instrument. Be sure to connect the ground lead. Set the instrument to
the factory default configuration by pressing the Save/Recall key, then the
Default Setup softkey. Then press the Autoscale key. You should see a display
similar to the following.
Autoscale with digital channels (54621D, 54622D, 54641D, and 54642D)
key, then press the Default Setup
Front-Panel Overview
To use digital channels to view a signal
Autoscale key to display
Undo Autoscale softkey before
softkey.
2-13