Replacing The Lens; Select The Iris Configuration - Axis P1346 User Manual

Network camera

Hide thumbs Also See for P1346:

Table of Contents

Replacing the lens

Note:

This chapter applies to the AXIS P1347 Network Camera; and to the AXIS P1346/-E Network Camera when the

firmware supports it. This may apply to other cameras that support P-iris in the future.

There are optional lenses for the AXIS P1347 Network Camera. To replace the lens in the camera:

1. Disconnect the iris cable.

2. Unscrew the standard lens; attach and screw on the new lens.

Note: There is no need to restart the camera after changing the lens. The camera

must however be restarted if you are interchanging between a P-iris, DC-Iris

or fixed/manual iris lens.

In order to set the focus and position the lens, the camera must be connected

to the network. For instructions, please refer to the Installation Guide

supplied with the camera.

1. Go to Video and Audio > Camera Settings from the Setup link in the camera's webpage.

2. Click Edit... against Iris configuration:. In the dialog that appears, choose the iris

that corresponds to the camera's lens from the drop-down list and click OK.

Note: For P-Iris lenses not listed in the drop-down list, download the iris configuration

file from www.axis.com. To do this click the Upload tab, browse to the file and

click Upload. After the file has been uploaded, select the iris from the drop-down

list and press OK.

In case you select a DC iris configuration for a P-iris lens, an error message appears against Iris configuration in the

Camera Settings page.

AXIS P1346/-E/AXIS P1347 - Product Description

Table of Contents

P1347-e P1346-e P1347