Storage - Axis P1346 User Manual

Traps for SNMP v1/v2
Traps are used by the camera to send messages to a management system for important events or status changes.
If Enable traps is selected, enter the email address where the trap message is to be sent as well as the Trap community that
should receive the message.
There are four types of traps available for AXIS P1346/-E/AXIS P1347.
• Cold start
• Warm start
• Link up
• Authentication failed
SNMP v3
SNMP V3 - provides encryption and secure passwords. HTTPS must be enabled. To use traps with SNMP v3 an SNMP v3
management application is required.
If the Enable SNMP v3 option is enabled, provide the Initial user password. Note that the initial password is activated only
when HTTPS is enabled and can only be set once.
If HTTPS is enabled, SNMP v1 and SNMP v2c should be disabled.
When SNMP configuration is ready, click Save to use the new settings or Reset to return to the default values.
UPnP™
The network camera includes support for UPnP™. UPnP™ is enabled by default, and the network camera then is automatically
detected by operating systems and clients that support this protocol.
RTP/H.264
These settings are the port range, IP address, port number (video and audio), and Time-To-Live value to use for the video
stream(s) in multicast H.264 format. Only certain IP addresses and port numbers should be used for multicast streams. For
more information, please see the online help.
Bonjour
The network camera includes support for Bonjour. When enabled, the camera is automatically detected by operating systems
and clients that support this protocol.

Storage

SD Card
The Disk Management window is used to set up and manage local storage. It is used to connect memory cards for recording
video, monitoring a disk's status, enabling automatic cleanup, and preventing a memory card's memory from being
overwritten.
Storage Device - is used to identify and monitor the status of the SD card. It shows the size of the SD card and how much
free space is available for storage. It is also used to mount and format SD cards for local storage.
Device Settings - is used to configure removal of recorded video. Automatic disk cleanup can be enabled and set up
according to a schedule, and an SD card can be locked to prevent storage removal.
AXIS P1346/-E/AXIS P1347 - System Options
41