Disable The Ocp; Clear The Overcurrent Condition - Agilent Technologies U8030A Series User Manual

2 Operation and Features
Programming the Overcurrent Protection
N O T E

Disable the OCP

Clear the overcurrent condition

56
4 Enable the OCP.
• Press the [Over Current] button again to end the
adjustment and enable the OCP.
• The display will show dOnE.
• The corresponding OCP annunciator (OCP1 or OCP2)
turns on.
To cancel this operation, allow the unit to idle for five seconds.
1 Select an output channel with OCP enabled.
• Press [1] to select Output 1, or
• Press [2] to select Output 2.
• The corresponding annunciator (OUT1 or OUT2) turns
on.
2 Disable the OCP.
• Press the [Over Current] button again to disable the OCP.
• The corresponding OCP annunciator (OCP1 or OCP2)
turns off.
The OCP trip can only occur if the corresponding output is
enabled. When the OCP trip occurs, the corresponding
output is disabled automatically.
• If the OCP trip occurs on Output 1, the display shows triP
on line 1 and the OCP1 annunciator blinks.
U8030A Series User's Guide