Set Up - Total Gym Fit Owner's Manual

TOTAL GYM FIT OWNER'S MANUAL |
®

Set Up

FULLY ASSEMBLED!
NO TOOLS REQUIRED!
Set up your Total Gym in 5 easy steps.
®
WARNING
!
KEEP HAIR, FINGERS, LOOSE CLOTHING, CHILDREN AND PETS
AWAY FROM HINGES AND OTHER MOVING PARTS TO AVOID
SERIOUS INJURY. ALSO, BE SURE TO HAVE THE YELLOW HEIGHT
ADJUSTMENT PIN AND SAFETY HITCH PIN LOCKED IN PLACE
BEFORE GETTING ON YOUR TOTAL GYM TO AVOID SEVERE INJURY.
STEP 1.
Lay shipping box flat and open carton top.
STEP 2.
Remove corner tape from the carton bottom (as indicated by the
X's). Remove all packaging materials, including cardboard inserts,
from your Total Gym . Remove the squat stand (optional) from under
®
the gym (as shown to the right) and install on opposite end into
receptacles.
5 To order optional accessories, please go to TotalGymCatalog.com
SET UP
STEP 3.
Bending knees, lift gym up from
opposite end of squat stand. Make
sure that it rests solidly on the squat
stand. Remove the accessories from
under the bench.
STEP 4.
Extend Total Gym out in the following manner:
®
4A. Make sure the handles are out to the sides before you begin
to unfold your unit. Keep hands and fingers away from pulley.
Place one hand on the edge of the frame. With your other
hand, pull the black Spring Loaded Pin Knob located at the right
rail. Continue to hold pin out while taking hold of the Vertical
Column and pulling up. Once in the full upright position, release
the black Spring Loaded Pin. You should hear it lock into place.
Vertical Column
4B. Continue to carefully lower the
rails slowly, unfolding the unit until
it is flat on the floor with the Vertical
Column in full upright position.
Be sure to support the frame in
the center to avoid having the
product drop suddenly onto the
floor or pinch fingers.
IMPORTANT: Be sure the black Spring Loaded Pin is locked
into place before using your unit. You will know the pin is locked
into place when you can see the end through the inside of the
rail bracket.
Back
Crossbar