Total Gym GTS Assembly And Set-Up

ToTAL Gym GTs hArdwAre & informATion Box conTenTs:
®
• Spanner Wrenches (2) • Quick Links (2)
ToTAL Gym GTs
®
• Plastic Axle Caps (2) • Strap Handles (2)
AssemBLy And seT-up insTrucTions
• Round Nuts (2)
LAT BAr AssemBLy
removinG ToTAL Gym GTs from The Box
After you remove your Total Gym GTS
®
1
Remove the lid of the Total Gym
to install the LAT bars. It should look like the picture below. Notice the shipping sleeve
shown and the round nuts must be removed one side at a time to install the LAT bars.
Sleeve
Nuts
2
Remove all interior boxes from the top and sides. Cut the tape on the end of
the box at the base of the tower. Unfold that end of the box.
11
Open the hardware box and remove the spanner wrenches.
The picture below shows tools and parts needed to install the LAT bars, found
in the hardware box: You need 2 round nuts, 2 spanner wrenches and 2
3
Stand the Total Gym GTS
TM
plastic axle caps.
the tower to stand.
• Assembly Instructions and Owner's Guide
• Assembly, Set-up and Storage DVD
from the box and unfold it, it is ready for you
box and set it aside.
®
upright and roll it to the location where you want
ToTAL Gym GTs Box conTenTs:
• Tower, Rail and Glideboard Assembly
• LAT Bars and Arm Pulley Cable Assembly
• Folding Platform
12
4
Install one LAT bar completely, then install the other to keep the GTS
Remove the folding platform and the telescoping squat stand parts from the
and safe.
bottom of the box.
13
Using both spanner wrenches, hold the inner round nut stationary with one
wrench (on the inside of the rail) and turn the round nut on the outside of the
rail to loosen and remove the shipping sleeve (shown below).
unfoLdinG ToTAL Gym
14
5
Carefully slide the shipping sleeve out while holding the bushing in. If the
Unlatch the rails from the tower.
bushing slides out accidentally, slide it back through the hole in the tower
cross arm and into the rail.
6
Standing at the side of the unit, with one hand
Shipping
behind the tower and the other hand on the
Sleeve
glideboard, tilt the unit slightly backward and
use your foot to push the rail base away from
the tower. The tower will follow the upper rails
Bushing
forward and then it will begin to pull away from
the rails, backward to an upright position.
Caution! The tower is designed to open
automatically by pulling away from the upper
rails as the rails begin to unfold. Do not force
or push the tower away from the rails, as this
may cause the tower to fall backward.
• Telescoping Squat Stand
TotalGym.com
• Folding Foot Holder
U.S. Customer Service: 858.586.6080
• Hardware & Information Box
stable
®
Latch
Hold
glideboard
Hold
tower
Push rail
base here
with foot