Repeat Timer Setting - Pioneer PDP-50MXE20 Technical Manual

24) REPEAT TIMER Setting

When two input modes have been set, they are displayed alternatively.
This can be used to set one screen, two screens, or video wall.
Factory setting: REPEAT TIMER ............ SINGLE
1. WORK TIME ............ 00H10M
INPUT MODE ........... INPUT1
2. WORK TIME ............ 00H10M
INPUT MODE ........... INPUT2
1 Enter the integrator mode.
(Refer to section 5.4.1, "About the Integrator Mode" (pg. 190).)
2 Select 'OPTION'.
3 Place the cursor on 'REPEAT TIMER' then press the [SET]
button.
4 Place the cursor on 'REPEAT TIMER' then use the [2/3]
buttons to change the settings.
Each time a [2/3] button is pressed, the setting changes
as shown below.
3
VIDEO WALL
VIDEO WALL ..... It operates REPEAT TIMER during video
wall.
MULTI ................ It operates REPEAT TIMER during two
screen display.
SINGLE .............. It operates REPEAT TIMER during
single screen display.
Each item is set as follows.
Select the item with the [5/∞] buttons and change its setting with the [2/3] buttons.
7 Setting the single screen REPEAT TIMER
• WORK TIME .......... It sets the display time in a range from one minute to 24 hours.
• INPUT MODE ........ It sets the signal that is displayed
Note
Perform this operation after turning the setting of DIVIDER in "5.4.3 Adjustments and setting in the Integrator Mode:
11) VIDEO WALL Setting (pg. 204)" to OFF.
3
3 3 3
SINGLE
MULTI
INPUT1 ⇔ INPUT2
Screen 4
R E P E AT
1 W O R K
I N P U T
3
2 W O R K
I N P U T
SET
SET
Integrator Mode
R E P E AT T I M E R
T I M E R : S I N G L E
T I M E : 0 0 H 1 0 M
M O D E : I N P U T 1
: 0 0 H 1 0 M
T I M E
M O D E : I N P U T 2
EXIT
MENU
227