Assigning An Id - Pioneer PDP-50MXE20 Technical Manual

13) Assigning an ID

This option assigns the ID necessary to adjust only the designated display in a video wall or to make an adjustment
using an RS-232C command. For details see "5.5 RS-232C Adjustment" (pg. 236).
Factory setting: ALL
1 Enter the integrator mode.
(Refer to section 5.4.1, "About the Integrator Mode" (pg. 190).)
2 Select 'OPTION'.
3 Place the cursor on 'ID NO. SET' then press the [SET]
button.
4 Press the [2/3] buttons to change the settings.
Each time a [2/3] button is pressed, the setting changes
as shown below.
3 ALL 2
ALL ............... ID number cannot be set so the panel can
be operated from all remote controls.
01H to FFH ... The ID number is set to the designated
number.
Display ID numbers may match the ID number that is displayed when the remote control's ID NO.
SET button is pressed. The remote control's [ID NO. SET], [CLEAR] buttons are operational.
Press the [SET] button to return to screen 3.
The 'ID NO. SET' settings are common for all inputs.
7 The Remote Control ID
When several Plasma Displays are installed at a single location, it is possible to operate only specified Plasma
Displays with the remote control. Set the following options:
Factory setting: ALL
1 Register panel ID numbers through the integrator menu.
2 Separately register the ID numbers for remote control use
with the [ID NO. SET] button on the remote control.
Press the [ID NO. SET] button to display screen 2.
Each time a [2/3] button is pressed, the setting changes
as shown below.
3 ALL 2
3 01H to FFH 2
3 01H to FFH 2
Integrator Mode
Screen 3
I N T E G R AT O R
P I C T U R E S C R E E N
P R O G R A M T I M E R
S C R E E N M A S K
S I D E M A S K
V I D E O WA L L
B A U D R A T E
I D N O . S E T
ENTER
SET
Screen 4
I D N O . S E T
SET
SET
Screen 2
I D S E L E C T
P O S I T I O N :
I D N U M B E R
SET
SET
I N P U T 1
S E T U P O P T I O N
:
G R E E N
:
1 2 0 0 B P S
:
0 1 H
EXIT
MENU
:
0 1 H
EXIT
MENU
1
:
A L L
EXIT
MENU
209