Attaching The Stand To The Plasma Display - Pioneer PDP-50MXE20 Technical Manual

[50MXE20 : 42MXE20]

4.5.5 Attaching the Stand to the Plasma Display

Caution
The Plasma Display is heavy, has no depth, and is
unstable, so be sure to have at least two people
assemble and install it.
Note
Insert the bolts in the holes vertically.
Place a sheet or protective cover to protect the display
from scratches or damage.
Assemble only with the Plasma Display lying flat on a
table or similar surface.
1 With the Plasma Display lying flat, insert and secure
the two Installation bolts 1 (M8 x 20 mm) in the
holes "a" located in center of the Plasma Display
housing.
At this point, tighten these bolts 1 only until the
threads are no longer visible when viewed from the
side (you will be unable to attach the display if the
bolts are screwed in completely).
Installation
1
bolt
Plasma Display
housing
Plasma Display
* Illustration depicts
50 inch display
Sheet
model.
Note
When laying down the Plasma Display, be careful so as
to not scratch or damage it.
Table Top Stand: PDK-TS01/PDK-TS07
Table. Regarding the stand pipe bolt holes when the
Plasma Display model Bolt holes used with stand orientation
50 inch display model
43 inch display model
42 inch display model
Note
C
that are sold separately.
2 Hook the stand pipe holes B onto the bolt heads of
Stop screwing
down the bolt
when the threads
are no longer
visible.
3 Pass the installation bolts 2 (M8 x 40 mm) through
1
Installation bolt
(M8 x 20 mm)
Holes "a"
(holes in center
of Plasma
Display)
4 Tighten the installation bolts 1 firmly with the
stand is used as a desktop stand
C
and ' indicate bolt holes for optional components
B
the installation bolts 1, then slide the stand
upwards to the Plasma Display until it engages the
installation bolts 1.
It slides no more than 19 mm (3/4 inch) because of
the structure of the stand.
the stand pipe holes B', and then screw them into
the main Plasma Display with the accessory
hexagonal wrench.
Move the stand so that the stand screw holes
and the nuts that connect the main display line
up correctly.
Be sure to tighten the bolts securely.
accessory hexagonal wrench.
Be sure to tighten the bolts securely.
Table top stand
B , B '
A , A '
A , A '
2
Installation bolts
(M8 x 40 mm)
(Step 3)
Slide the stand
(Step 2)
101